Recommended UseWash primer is a two component coating. It is used as a pre- treatment coating on clean and unpainted ferrous & non- ferrous substrates such as aluminum, copper, tin, cadmium, zinc. brass & galvanized steel. Prior to applying the new coating system in order to increase adhesion and corrosion resistance. As a result, we offer wash primer as connection factor between paint and surface and it can also be used as an under coat.
Surface Preparation-The surface should be free form any rust, moisture, mill scale, oil & grease - Mechanical & chemical surface preparation methods should be performed depending on the type of contamination, the coating system environ mental condition & the service life - Apply the paint immediately followed by surface preparation .
Application Procedure- Flush equipment with recommended cleaner before use - Stir component A (base) with a Power Mixer. - Add hardener to base in the proper Mixing continue stirring for 20-30 Minutes. - After 30 minutes add Shakiba’s Thinner until color change from yellow to yellow green,then wash primer is ready to use. - Use Shakiba’s thinner for adjusting the viscosity. -The con sumption depends on temperature & type of equipment & thickness paint .
Safety- This product is flammable it must be kept away from heat, flash & flame - keep container closed use with adequate ventilation & Earth - Prolonged & repeated contact with skin may be harmful - In case of eye contact flush with plenty of water and check with a medical doctor.
Note- Pot life, drying time is dependent on air and steel temperature, applied film thickness. - Never apply coatings under environmental condition. -Adjusting the viscosity & pressure. -This information given 25°C temperature and changed temperature cause to change data. -Don’t use different thinner; otherwise we decline all responsibilities of it. -For more information, please call to sale engineering expert .